Used in Trane, Goodman, Carrier, Payne, Bryant, York and many other brands of Air Conditioning equipment
Dual motor capacitors enables the motor or compressor to run smoothly and more efficient by storing a charge for the motor when the voltage reaches the zero point and keeps the voltage steady instead of all the up and down voltage drops.
- Hermetically Sealed
- Oil Filled
- Non PCB Oil
- Metal Case
- Metalic Film
- Four Blade Connection Terminals
- Insulated Terminals
- UL Listed
|Capacitance||40 ~ 7.5 uF.|
|Rated Voltage||370 VAC|
|Capacitor Type||Aluminum Electrolytic|
How to install a new Dual Run Capacitor ?
- Warning: TURN ALL ELECTRICAL POWER OFF BEFORE WORKING ON ANY ELECTRICAL APPLIANCE.
- Use a screwdriver to shorten the terminals and discharge the electricity from it.
- Remove one wire at a time from the old capacitor and Install it to the correct terminal on the new capacitor.
- On the top of the capacitor find three markings stamped into the metal next to each terminal wire port.
- One terminal is marked "HERM", Means Hermetic which represents the compressor.
- One Terminal is marked "C", this is the COMMON side of the capacitor.
- Terminal "F" or "FAN", Means the Condenser Fan Motor.
Vertical mounting of the capacitor with the terminals
up is recommended. However, horizontal mounting is
acceptable providing the vent is located in the up position.
Vertical mounting with the terminals down is not
recommended because the capacitor life may be reduced
and the operation of the pressure relief vent impaired.
Because the watt–second value of these capacitors is
high, precautions should be taken during the testing
of these devices.
Discharge resistors should be specified when there is
a possibility of a residual charge left on the capacitor
or to protect contacts. Mis–application, such as exceeding
design limits or applying continuous AC voltage,
may result in destruction or explosion of capacitors.
- In Stock
V – Volts
VAC – Volts Alternating Current
Run capacitors are designed for continuous duty, and they are energized the entire time the motor is running. Run capacitors are rated in a range of 3–70 microfarads (µF), with voltage classifications of 370 V or 440 V Single phase electric motors need a capacitor to energize a second-phase winding. If the wrong run capacitor is installed, the motor will not have an even magnetic field, and this will cause the rotor to hesitate at those spots that are uneven.
Start capacitors briefly increase motor starting torque and allow a motor to be cycled on and off rapidly. Start capacitors have ratings above 70 microfarads (µF), with three major voltage classifications: 125 V, 250 V, and 330 V. A start capacitor stays energized long enough to rapidly bring the motor to 3/4 of full speed and is then taken out of the circuit, such as by a centrifugal switch that releases when rotating at or around that speed.
Dual run capacitors
A dual run capacitor supports 2 electric motors, such as in large air conditioner or heat pump units, with both a fan motor and a compressor motor. The dual capacitor has 3 terminals labeled "C", "FAN", and "HERM" for the common, fan, and hermetic compressor connections.
Round dual run capacitors (shaped as round cylinders) are commonly used for air conditioning, to help in the starting of the compressor and the condenser fan motor. Dual capacitors come in a variety of sizes, depending on microfarads (µF), such as 40 plus 5 µF, and also the voltage. A 440 volt capacitor can be used in place of a 370 volt, but not a 370 in place of a 440 volt. The microfarads must stay the same within 5% of its original value. An oval dual run capacitor could be used instead of a round capacitor, but the mounting strap should be changed to better fit the oval shape.
No FAQ found